Managed Home Wi-Fi

Your box includes:

• 1x Cisco access point
• 1x Network cable

1. Choose a central location in your home for the best wireless coverage.
2. Plug the network cable into the access point's network port (labeled in yellow).
3. Plug the other end of the cable into your wall network port.
4. The LED should start blinking. If it does not blink, your wall port may need to be activated.
5. Wait 3 to 5 minutes for the device to initialize.

Once ready, you will see these two networks appear:

1. Connect your phone or laptop to Cisco-HomeWiFi-2.4 using the default credentials below.

   Network Cisco-HomeWiFi-2.4

   Password default@1234
2. Open the access point configuration page using one of these two methods:

   Option A

   Scan the QR code on the back of the device.

   Option B

   Browse to the address below. Replace XXXX with the device name shown on the label.

   https:// HAP-XXXX.kaust.edu.sa
3. You may see a certificate warning. This is expected and safe. Click “Accept and proceed.”
4. On the login screen, enter the following:

   Username admin

   Password MAC address printed on the back of the device

You will be prompted to change your password immediately after your first login.

1. Go to the CONFIGURATION tab.
2. Update the username and password fields.
3. Click Apply.
4. Log back in using your new credentials.

1. Go to the CONFIGURATION tab.
2. In the left menu, select SSID, then 2.4GHz.
3. Make sure both Enabled and Broadcast are checked.
4. In the SSID field, enter your preferred network name.
5. Confirm that both WPA-PSK and WPA2-PSK are set to Enabled.
6. In the WPA Passphrase field, enter your new Wi-Fi password.
7. Repeat these steps for the 5GHz network.
8. If you have more than one access point, repeat for each device.